Christie APS Series Service Manual page 56

■ HEAT SINK FAN
Sticking pressure: More than 0.98N/cm2
Adjusting the length of the lead by tape
Adjust the length of the lead by tape as shown in the following.
Adjusting the length of the lead of two HEAT SINK FANs (same ones)
HEAT SINK FAN1
HEAT SINK FAN2
1. HEAT SINK FAN1 lead
No need to adjust the length of a cable.
Wire the cable as same length as delivered (280mm).
2. HEAT SINK FAN2 lead
Adjusting the length of the lead by sticking the tape
LWU650-APS/LWU530-APS
Service Manual
LWU650-APS / LWU530-APS
Sticking pressure: More than 0.98N/cm2
Reference
for sticking
Reference
for sticking
FAN cable
Reference
for sticking
55
Reference for sticking
Reference
FIX CUSHION
for sticking
Reference
for sticking
Be careful not to misassemble.
Labeled side
Cable
Reference for sticking
Cutout
Stick FAN CUSHION
along an arrow in the
drawing from a
reference for sticking.
The number of folding
the lead
Second
[Reference for folding back the lead]
Fold back the lead twice according to the length
shown above.
Wind a tape tightly at the center of folded lead.
Use ZTP03 (NITTO tape No.5 W9mm x L30mm).
020-001522-01 Rev. 1 (11-2018)
LIT MAN SERV APS Series
First