Christie APS Series Service Manual page 13

POWER/STATUS
indicator
Blinking
In Red
9 times
Blinking
In Red
9 times
Normally lighting in
Orange.
Blinking In Green 2
times for approx. 3
seconds.
Blinking In Green for
approx. 3 seconds.
Lighting
Green
In
Lighting
In Orange.
Normally lighting in
Green.
Blinking 1 time for
approx. 3 seconds.
Blinking
In Red
2 times
Other than those above
NOTE
• When the interior portion has become overheated, for safety purposes,
the projector is automatically shut down, and the indicator lamps may also be
turned off. In such a case, disconnect the power cord, and wait at
After the projector has sufficiently cooled down, turn the power on again.
LWU650-APS/LWU530-APS
Service Manual
LWU650-APS / LWU530-APS
STATUS
DETAIL
indicator
There is a possibility that the interior portion
has become overcooled.
Blinking
In Red Please use the unit within the usage temperature
parameters (0°C to 40°C).
1 ～ 4 times
After the treatment, turn the power on.
Blinking The illuminance system is operating in degraded
In Red mode.
The image color may not be projected correctly.
5 ～ 7 times
STANDBY MODE is set to QUICK START.
Refer to STANDBY MODE.
Turned
off
At least 1 "Power ON" schedule is saved to the
Turned projector.
Please refer to Schedule Settings section of
off
User's Manual - Network Guide.
The projector received the remote control signal
Blinking when ALL is selected for REMOTE CONTROL in
In Red KEY LOCK.
CONTROL PANEL was operated when ALL is
1 time
selected for CONTROL PANEL in KEY LOCK.
PIN LOCK or TRANSITION DETECTOR function
is active.
Blinking In Please see SECURITY menu > PIN LOCK or
Red 1 time
TRANSITION DETECTOR
If the same indication is displayed after the remedy,
please contact your dealer or service company.
Blank(black) or AV Mute(black) is on.
Turned
Press any button on the remote control or on the
off
control panel to disable Blank or AV Mute.
The interior portion has become heated.
Turn the power off, and allow the projector to cool
down at least 20 minutes. After the projector has
sufficiently cooled down, confirm the following items,
and then turn the power on again.
• Is there blockage of the air passage aperture?
• Is the air filter dirty?
Blinking
• Does the peripheral temperature exceed 40°C?
In Red
• Is the setting for ALTITUDE appropriate?
1 ～ 4 times
• Is the exhaust air (hot/cold) from peripheral
equipment blowing against the ventilation opening
of projector?
For details on ALTITUDE, refer to ALTITUDE of
SERVICE in the OPTION menu. If the projector is
used with a wrong setting, it may cause damage to
the projector itself or the parts inside.
Other error has occurred.
Contact your dealer or service company.
Description
least 20 minutes.
12
020-001522-01 Rev. 1 (11-2018)
LIT MAN SERV APS Series