Christie APS Series Service Manual page 49

Wiring of MAIN PCB -5
Wiring of CNMPW
Holding the both ends of CNMPW by
both hands, stretch the cables straightly
so that they will not loosen.
Stretching CNMPW, connect it to
MAIN PCB (E800).
Completion
LWU650-APS/LWU530-APS
Service Manual
LWU650-APS / LWU530-APS
1
POW CABLE BKT
CNMPW
Wire CNMPW under POW CABLE BKT. Make sure
that the cables do not stick out from POW CABLE BKT.
Be careful not to pinch CNMPW when screwing down
POW CABLE BKT.
NOTE
Connect CNMPW which is to be connected to E800
connector before connecting connectors on B-side
(the side which connectors are equipped on),
because it is equipped on A-side of MAIN PCB.
It would be difficult to connect if you try to connect it
after connecting connectors on B-side because the
MAIN PCB has been fixed.
Make sure that CNMPW is locked after inserting it.
CNMPW
NOTE
Wire CNMPW so that it will not be on the left of a blue line
(in order to put it in the POWER UNIT CIRCUIT side
indicated by a yellow arrow). This is to prevent
UPPER CASE from pinching CNMPW.
POW CABLE BKT
48
2
020-001522-01 Rev. 1 (11-2018)
LIT MAN SERV APS Series