Christie APS Series Service Manual page 62

■ POW SUB ASSY - 1
Use a specified jig.
Use a specified jig to assemble the BOTTOM CASE.
It prevents the projector from being bent or being damaged to its appearance when you assemble it.
Use a specified jig.
Use a specified jig to assemble the BOTTOM CASE.
It prevents the projector from being bent or being damaged to its appearance when you assemble it.
LWU650-APS/LWU530-APS
Service Manual
LWU650-APS / LWU530-APS
②
Lower CABLE FIX SHEET B
and hook it on POW SUB ASSY.
POW SUB ASSY
②
Lower CABLE FIX SHEET B
and hook it on POW SUB ASSY.
POW SUB ASSY
①
Pass POW-P cable under
CABLE FIX SHEET B.
Replacing the power supply
1. Remove the engine.
2. Unroute the harness on the white duct.
3. Remove four screws to remove the white
duct.
4. Remove the power supply duct and metal
shield (two screws).
5. Remove the four screws located on the
black plastic part of the power supply.
6. Unroute the two harness cables. Green
ground cable must be on the bottom upon
reinstall.
7. Remove the AC inlet screw.
To remove the metal shielding:
8. Remove the four screws.
9. Remove the ground screw (black cable).
10. Remove the two mylar shields.
11. Remove all the harnesses.
12. Replace the power supply PCB.
Replacing the power supply fan
1. Remove the power supply.
2. Remove the two screws.
3. Remove and replace the fan.
4. To reinstall the fan, repeat the above steps
in reverse order.
61
①
Pass POW-P cable under
CABLE FIX SHEET B.
020-001522-01 Rev. 1 (11-2018)
LIT MAN SERV APS Series