CONFIRMATION OF THE ft CONTROL SOFTWARE VERSION
The following describes how to check the version of ft control software, which consists of various
types of software for fault tolerance. Perform the procedure when you need to check the ft control
software version of the current system before adding units or attachment to NEC Express5800/ft
series.
A tool for checking the version is provided. Confirm the version afollowing the steps below:
1.
Log in the system as an authorized Administrator.
2.
Insert the provided "NEC EXPRESSBUILDER" CD-ROM in the CD-ROM drive.
Use the "NEC Express5800/ft series ft control software UPDATE" CD-ROM, if it is
available.
3.
Run the tool installed in the CD to check the version of ft control software.
Tool name: ftVerChk.exe
Location:
The ft control software version of the current system is displayed.
This completes confirmation of the version.
<CD-ROM drive>: FTSVTOOL\VERSION
Setup 3-47