NEC Express5800/320Lb User Manual page 125

Boot
To change the boot order of devices connected to the server
Select [Boot] and specify the boot order.
To display POST check results
Select [Advanced] → [Advanced] → [Boot-time Diagnostic Screen] → [Enabled].
You can also press Esc while the NEC log is on the screen to display POST check results.
To control from the HW console
Remote operation via LAN
Select [Advanced] → [Advanced] → [RomPilot Support] → [Enabled].
Remote operation via WAN
Select [System Hardware] → [Console Redirection] and set each item.
Memory
To check the installed memory (DIMM) status
Select [Advanced] → [Memory Reconfiguration] and check the status indications.
Saving the Configuration Data
To save the BIOS configuration data
Select [Exit] → [Save Changes & Exit] or [Save Changes].
To discard changes to the BIOS configuration data
Select [Exit] → [Exit Without Saving Changes] or [Load Previous Value].
To restore the factory-set BIOS configuration data
Select [Exit] → [Get Default Values].
System Configuration 4-7