NEC Express5800/320Lb User Manual page 347

How to Locate Failed Disks
This section describes a procedure to locate failed disks.
Open [Data Viewer] from ESMPRO Manager.
1.
If trouble occurs, the color changes from green to red.
In this case, you will notice that there is trouble with both the SCSI Enclosures (ID:10/40)
and (ID:11/40).
Check the SCSI Enclosures (ID:10/40) and (ID:11/40) on the tree.
2.
See the path information in [General Information] of [SCSI Slot] to locate a group of
3.5-inch device bays that corresponds to each enclosure.
The table below shows the path information on Groups 1 and 2:
Slot
Group1
Group2
See the path information in [General Information] of [SCSI Slot (ID: 10/40/1)].
3.
It shows that PCI module, SCSI adapter, and SCSI bus are 10, 5, and 0, respectively.
This allows you to find that SCSI Slot (ID: 10/40/1) belongs to Group 1. SCSI slots
under SCSI Enclosure (ID: 10/40/1) correspond to Group 1. Therefore, Group 2
PCI module SCSI adapter
10
11
SCSI bus
5 0
5 0
System Upgrade 8-11