NEC Express5800/320Lb User Manual page 311

On-screen error message
0B29 Unsupported Processor
detected on Processor 2
0B30 CPU FAN #1 Alarm
occurred
0B31 CPU FAN #2 Alarm
occurred
0B32 CPU FAN #3 Alarm
occurred
0B40 Invalid System
Configuration Data
0B41 System Configuration
Data Read error
0B42 Resource Conflict
0B43 Warning: IRQ not
configured
0B44 Expansion Rom not
initialized
0B45 System Configuration
Data Write error
0B47 Missing date and time
synchronization
0B49 BMC Issued Reset
Command, but failed
System Reset
0B6E DIMMs are installed out
of order
0B70 The error occurred
during temperature
sensor reading
0B71 System temperature out
of Range
Cause
The processor (CPU) not
supported by this server is
installed in Processor 2.
•
Dusts are clogged in fan.
•
Fan is faulty.
•
CPU module board is faulty.
•
Dusts are clogged in fan.
•
Fan is faulty.
•
PCI module board is faulty.
•
Configuration error in
SETUP.
•
CPU/PCI module board is
faulty.
•
Configuration error in
SETUP.
•
CPU/PCI module board is
faulty.
Configuration error in SETUP.
Configuration error in SETUP.
Configuration error in SETUP.
•
Configuration error in
SETUP.
•
CPU/PCI module board is
faulty.
The date and time are
incorrect due to a
communication error between
BMCs.
•
System cannot be reset by
BMC's reset command.
•
DIMM is faulty.
•
SMBus device is faulty.
•
SMBus is faulty.
•
Ambient temperature is out
of range.
•
Fan is faulty.
•
CPU/PCI module board is
faulty.
Troubleshooting 7-17
Action
Install the CPU appropriate to
the server.
•
Replace the fan.
•
Replace the CPU module
board.
•
Connect fan cable properly.
•
Replace the fan.
•
Replace the PCI module
board.
•
Connect fan cable properly.
•
Reset the setting by
selecting [Yes] at [Reset
Configuration Data]
•
Replace the CPU/PCI
module board.
•
Reset the setting by
selecting [Yes] at [Reset
Configuration Data]
•
Replace the CPU/PCI
module board.
Correct device configuration in
SETUP
Correct settings in SETUP
In SETUP, disable
decompression of expansion
ROM on unnecessary optional
PCI cards.
•
Reset the setting by
selecting [Yes] at [Reset
Configuration Data]
•
Replace the CPU/PCI
module board.
•
Restart the system.
•
Re-set the date and time in
SETUP.
If the error persists, replace the
PCI module board.
Replace PCI module board.
Replace DIMM.
Replace the CPU/PCI module
or back panel board.
•
Check the setting in SETUP
•
Clean the fan.
•
Replace the fan.
•
Replace the CPU/PCI
module board.