Chapter 1 Installing OS
2.2
Confirmation of the ft Server Control Software Version
The following describes how to check the version of ft Server Control Software. Perform the procedure when you need
to check the ft Server Control Software version of the current system such as before adding units or attachment to
NEC Express5800/ft series.
Confirm the version following the steps below:
Run the following command on the ftSys Management Appliance.
1.
# /opt/ft/bin/ftsmaint –v
ftsys-ftsmaint version 5.0.0-214
The version of the ft Server Control Software in operation is displayed.
Make sure that the version is exactly same as that shown above.
This completes the version confirmation.
Running the following command may fail if the necessary process does not run
Note
immediately after the system startup. In this case, wait for a while (several minutes or so),
and try again.
Express5800/R320c-E4, R320c-M4 Installation Guide (VMware)
2. Procedures after Completion of Installation
59