NEC Express5800/320Lb User Manual page 100

3-30 Setup
9.
Click [Finish] to upgrade the disk to a dynamic disk.
If the selected disk contains a system partition, you will have to restart the computer to
complete the upgrade of the disk. The message also states that file systems on any of the
disks to be upgrade will be forcedly dismounted. This means if any file systems are in use
at the time of upgrade, they will be dismounted, so that the upgrade can continue.
Before restarting the server, check if the PCI module has a dual configuration.
IMPORTANT:
For the upgrade to the dynamic disk in which the system is installed, machine restarting
may be requested several times. Always restart the machine after confirming the PCI
module duplication. When the machine is restarted before the PCI module duplication,
the dual LAN may become invalid If the dual LAN becomes invalid, make the settings
of dual Lan again.
Check the PCI module duplication as follows:
The PCI module duplication is valid if both the status LED of PCI module #1 and that
of PCI module #2 are lit green. See "PCI Module Status LED 1/2" for details.
10.
After reboot, when [VERITAS Volume Manager] appears, make settings of the disk to
mirror volumes.
When [Disk Upgrade and Signature] wizard appears, perform a disk upgrade and
signature.
IMPORTANT:
corresponding slot.
See "3.5-inch Hard Disk Drive" in Chapter 8 for details.
11.
Choose "Display a list of the known drivers for this device so that I can choose a specific
driver", click [Next].
Note the following when restarting the machine for dual disk settings:
A disk for mirroring should be placed in its