Chapter 1 Installing OS
2.2
Confirmation of the ft control software Version
The following describes how to check the version of ft control software.
Confirm the version following the steps below:
1.
Run the following command on the ftSys Management Appliance.
# /opt/ft/bin/ftsmaint –v
ftsys-ftsmaint version X.X.X-XXX
The version of the ft control software in operation is displayed.
Check that this version is the same as that of "Host software version matches appliance" displayed
in the ft-verify command according to Chapter 1 (1.11.3 Checking status of ft server).
This completes the version confirmation.
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Installation Guide (VMware)
70
Note
Running the following command may fail if the necessary process does not run
immediately after the system startup. In this case, wait for a while (several minutes or so),
and try again.
2. Procedures after Completion of Installation