Collection Of The Memory Dump - NEC Express5800/320Lb User Manual

Collection of the Memory Dump

If a failure occurs, the memory data should be dumped to acquire the required information. If you
stored the dump data in a DAT, label it so as to indicate the software (e.g. NTBackup) you used for
storing it. You may save the diagnosis data to a desired destination.
IMPORTANT:
Consult with your sales agent before dumping the memory. Executing memory
dumping while the server is in the normal operation may affect the system
operation.
Restarting the system due to an error may display a message indicating
insufficient virtual memory. Ignore this message and proceed. Restarting the
system again may result in dumping improper data.
Preparing for Memory Dump
Memory dumping with the DUMP switch may disable the server to restart. In such a case, it is
required to force the server to shut down. This forced shutdown, however, is not available if
"Masked" is selected for "Power Switch Mask" on the Security menu of the BIOS setup utility,
SETUP, because this setting disables POWER switch operation.
Follow the procedure below to change the setting to enable the forced shutdown and restart of the
server.
1.
Power on the server and start the BIOS setup utility, SETUP.
2.
Select "Unmasked" for "Power Switch Mask" in the Security menu.
3.
Save the configuration data and exit the SETUP.
Saving Dump Files
Press the DUMP switch to save the dump file
when an error occurs. Insert a metal pin (a
straightened large paper clip will make a
substitute) into the switch hole to press the
DUMP switch.
Pressing the DUMP switch saves the dump file
in the specified directory. (Memory dumping
may not be available when the CPU stalls.)
IMPORTANT:
toothpick or plastic stick that is
easy to break.
Do not use a
Troubleshooting 7-37
Dump switches