NEC Express5800/320Lb User Manual page 404

8-68 System Upgrade
Mount the N8804-001P1 100BASE-TX adapter to the slot with the same number in PCI
1.
module #1 and #2, and then start Windows 2000 Advanced Server.
After starting Windows 2000 Advanced Server, the drivers are installed automatically.
IMPORTANT:
appears, click the [Yes] button.
Build a dual LAN configuration. (See "Setting Dual LAN Configuration")
2.
IMPORTANT:
You can also select [Load Balancing] in step 3 in "Setting Dual
LAN Configuration". In this case, [Team #1:Adaptive Load
Balancing Mode] is added to Network Component Tree.
Moreover, select [Stratus AA-U51500 10/100 Enet Adapter] instead
of [Stratus emb-82559 10/100 Enet Adapter] in Steps 4 and 5.
If you build a dual configuration by using two pairs of adapters in
Step 5, add an adapter in the same way.
PCI Board Status LED Indications
LED
Description
indications
Green Duplex is specified, however,
the server works in simplex
mode.
Off PCI board is properly installed
and operates in non-duplex
mode (AFT, ALB). (Does not
depend on simplex or duplex.)
POST is operating or the PCI
board is installed to operate in
the duplex mode.
The PCI board is not installed
yet, the PCI board is installed
incorrectly, or the power is not
supplied.
Red The PCI board is not mounted;
is mounted incorrectly; or power
is not supplied.
Although the PCI board is
mounted, it may be offline or not
be working.
If the [Digital Signature Not Found] dialog box
Action
Specify duplex (AFT, ALB).
Specify an appropriate driver.
In non-duplex mode, no special problem
occurs.
The system is operating normally in duplex
mode.
Mount the PCI board correctly.
If the PCI board was not mounted, there is no
problem.
Check the condition of power unit.
Remount the PCI module.
Wait for a while until the indication changes. If
the indication unchanged, check the PCI board
slot status using NEC ESMPRO Manager.
Make the slot of the board installed from NEC
ESMPRO Manager online.
Mount the PCI board correctly.