NEC Express5800/320Lb User Manual page 141

Console Redirection
Select "Console Redirection" on the System Hardware menu and press Enter to display the
following screen.
Serial Port Address:
Baud Rate:
Flow Control:
Console Connection:
F1 Help
Esc Exit
See the table below for setup options on the screen.
Option Parameter
Serial Port [Disabled]
Address
On-board COM B
Baud Rate [19.2K]
57.6K
Flow Control [None]
XON/XOFF
Console [Direct]
Connection
Via modem
Phoenix BIOS Setup Utility
System Hardware
Console Redirection
[Disabled]
[19.2K]
[XON/XOFF]
[Direct]
-/+ Change Values
Select Item
Enter Select
Select Menu
Description
Select a serial port to connect the HW
console.
Selecting "On-board COM B" changes
"Boot-time Diagnostic Screen" to
"Enabled".
Select a baud rate for communications
with the connected HW console.
Select a flow control method.
Select a connection with the HW console.
System Configuration 4-23
Item Specific Help
If enabled, the console
will be redirected to
this port.
F9 Setup Defaults
Sub-Menu F10 Save Changes & Exit
Your Setting
[ ]: Factory-set