NEC Express5800/320Lb User Manual page 252

5-90 Installing and Using Utilities
Connect from the Management PC Linked through LAN
On the management PC that is linked through LAN, perform the steps below:
Start the management PC where MWA is installed. From the Start menu, select
1.
[Program] → [NEC MWA] → [MWA].
When MWA starts, the initial screen "Remote Control Manager" will appear.
Insert a formatted 1.44MB floppy disk into the drive.
2.
From MWA's [File] menu, select [Configuration] command to open [Configuration]
3.
dialog box.
Select [New] to display the [Select a model] dialog box.
4.
Check [Write to FD] and select an applicable model to open [Configuration for ft Series]
5.
dialog box.
Ex) The model name is printed on the front cover like "NEC Express5800/320Lb," or
"NEC Express5800/320Lb-R."
[Configuration for ft Series] dialog box, specify/register configuration information
6.
including the names of computers to be managed, and then write the information to FD as
the following filename:
<Filename>
CSL_LESS.CFG
Specify the items as follows:
IP address:
Subnet mask: arbitrary
Right-clicking the server name to open the pop-up menu, from which select [Property]
7.
command to open [Property] dialog box.
When the [Property] dialog box appears: specify the items as follows:
8.
<[ID] page>
Connection mode:
<[Alert notification] page>
Uncheck [Use Default Settings] and check [Reset] of [Activate].
arbitrary Default gateway:
Primary contact:
LAN
arbitrary
Management PC's IP address