NEC Express5800/320Lb User Manual page 232

5-70 Installing and Using Utilities
Start the other module stopped.
7.
Starting the module causes the firmware to be updated automatically. However, if the
[Enable automatic firmware update] property is invalid, update the module in the
procedure as follows:
(1) Check the current state with the "State" display on the target component screen. If the
component is operating, stop the component.
(2) Click the [Firmware Update] button in the
[Update] screen for the target component.
(3) Select the update method in the [Firmware
Update] dialog box and click the [Run] button.
(4) Start the module.
Under the following conditions, the modules can have the same
new firmware version by copying the firmware between
modules.
Due to the replacement of either of the CPU modules, the version of the firmware in a
module does not match that in another module.
The image data of the update firmware has not been acquired yet.
Start the system only with the CPU module of the copy source.
1.
Make invalid the [Enable automatic firmware update] property.
2.
Select the target component in the [FTServer] tree.
3.
Check the current state with the "State" display on the screen of the CPU module to be
4.
copy destination. If the module is operating, stop the module.
Click the [Firmware Update] button in the [Update] screen for the target component.
5.
When the firmware update dialog appears, check [Copy firmware from Online module to
6.
Offline one.] to run the firmware update.
Copying the firmware in the online module to the offline module allows the firmware
update to be completed.
Start the inactive module.
7.