NEC Express5800/320Lb User Manual page 334

7-40 Troubleshooting
In the steps below, repair the system using information inside the disk instead of a system
repair disk:
1.
Modify the BIOS settings.
Select [Advanced] → [Monitoring Configuration], and "Disable" the setting of [Boot
Monitoring]. For details, see Chapter 4 "Monitoring Configuration".
2.
Power on the system.
3.
Insert the Windows 2000 Advanced Server CD-ROM into the drive of the server.
4.
Then, reset (pressing Ctrl + Alt + Delete) or power off/on NEC Express5800/ft series to
reboot it.
5.
Wait until message "Press any key to boot from CD" appears on the screen.
6.
Press any key to select the start from CD-ROM.
IMPORTANT: Unless an arbitrary key is pressed during the display of
the message, the system is started from the hard disk drive. The repair
process cannot be started.
7.
Wait until message "Press F6 if..." appears on the screen.
8.
Press the F5 and F6 quickly.
IMPORTANT: If you press neither the F5 nor F6, the repair process is
not started.
9.
If the text-base setup is started, follow the directions on the screen to proceed.
As you follow the directions, the screen for selecting HAL will appear.
10.
Insert the Windows 2000 OEM-DISK for EXPRESSBUILDER into the floppy disk drive
and specify the module saved in the OEM disk.
As you follow the directions, the screen for selecting the SCSI driver will appear.
11.
Insert the Windows 2000 OEM-DISK for EXPRESSBUILDER into the floppy disk drive
and specify the SCSI driver saved in the OEM disk.
As you follow the directions, the screen for selecting the SCSI driver will appear.
NOTE: The OEM disk contains more than one SCSI driver. Press S to
select all the SCSI drivers.
Message "Press R key to repair Windows 2000 already installed" appears.
12.
Press R to select the repair option.
13.
Select the type of the keyboard.