NEC Express5800/320Lb User Manual page 150

4-32 System Configuration
SCSI Device Settings
If you put the cursor on "SCSI Device Settings" with keyboard cursors (↓ ↓ ↓ ↓ and ↑ ↑ ↑ ↑ ) in the
"Configuration Settings" menu and press Enter, the screen for setting the information on the device
connected to the host adapter appears.
The table below shows the parameters of the setting items and their factory settings.
IMPORTANT: The settings can be made for each SCSI bus.
Submenu item Parameter
SCSI Bus0
Disconnects OK [Yes]
No*
Check Parity [Yes]
No
Enable LUNs [Yes]
No
Enable PPR [Yes]
No
Enable Device [Yes]
No
Negotiate Wide [Yes]
No
Negotiate [Yes]
Synchronous
No
Tagged Queuing [Yes]
No
Sync Offset 00, 02, 04, 06, 08,
10, 12, 14, 16, 18,
20, 22, [24]
Sync Period
[9] 160 (Ultra3
10 80 (Ultra2
12 40 (Ultra
25 20 (Fast
40 12.5
Exec Throttle 1, 4, 8, [16], 32,
64, 128, 255
SCSI Bus1
[Yes]
No*
[Yes]
No
[Yes]
No
[Yes]
No
[Yes]
No
[Yes]
No
[Yes]
No
[Yes]
No
00, 02, 04, 06, [08],
10, 12, 14, 16, 18,
20, 22, 24
Transfer Rate Transfer Rate
(Mbytes/sec) (Mbytes/sec)
9 160 (Ultra3
SCSI) SCSI)
[10] 80 (Ultra2
SCSI) SCSI)
12 40 (Ultra
SCSI) SCSI)
25 20 (Fast
SCSI) SCSI)
40 12.5
1, 4, 8, [16], 32, 64,
128, 255
Description
Specify whether the disconnection of
SCSI devices from the SCSI bus is
enabled or disabled.
* On Bus0, select "No" for ID8.
Specify whether the parity check is
provided or not.
Specify whether more than one LUN
numbers are given to SCSI ID.
Do not change the factory setting.
Do not change the factory setting.
Specify whether the wide (32 bits)
transfer is enabled or disabled.
Specify whether the synchronous
transfer is enabled or disabled.
Do not change the factory setting.
Select the proper offset value in
synchronous transfer.
Select the proper speed in
synchronous transfer.
Do not change the factory setting.
[ ]: Factory-set