NEC Express5800/320Lb User Manual page 234

5-72 Installing and Using Utilities
After the BIOS for a single CPU module is completed, click the [Jump Switch] button.
7.
The module completely updated is started and the module under operation is stopped.
Start the other inactive module.
8.
Starting the module causes the firmware to be updated automatically. However, if the
[Enable automatic firmware update] property is disabled, update the module in the
procedure as follows:
(1) Check the current state with the "State" display
on the target component screen. If the component
is operating, stop the component.
(2) Click the [Firmware Update] button in the
[Update] screen for the target component.
(3) Select the update method in the [Firmware
Update] dialog box and click the [Run] button.
(4) Start the module.
Under the following conditions, the modules can have the same new firmware version by copying
the firmware between modules.
Due to the replacement of either of the CPU modules, the version of the firmware in a
module does not match that in another module.
The image data of the update firmware has not been acquired yet.
Start the system only with the CPU module of the copy source.
1.
Make invalid the [Enable automatic firmware update] property.
2.
Select the target component with the ft server utility.
3.
Check the current state with the "State" display on the screen of the CPU module to be
4.
copy destination. If the module is operating, stop the module.
Click the [Firmware Update] button in the [Update] screen for the target component.
5.
When the firmware update dialog appears, check [Copy firmware from Onlinemodule to
6.
Offline one] to run the firmware update.
Copying the firmware in the online site to the offline site allows the firmware update to be
completed.
Start the inactive module.
7.