Confirmation Of The Ft Control Software Version - NEC Express5800/R320g-E4 Installation Manual

Chapter 1 Installing Operating System
2.2

Confirmation of the ft control software Version

The following describes how to check the version of ft control software.
Confirm the version following the steps below:
1. Run the following command on the ftSys Management Appliance.
# /opt/ft/bin/ftsmaint –v
ftsys-ftsmaint version 6.7.1-117
The version of the ft control software in operation is displayed.
Make sure that the version is exactly same as those shown above.
This completes the version confirmation.
Note Running the following command may fail if the necessary process does not run immediately
after the system startup. In this case, wait for a while (several minutes or so), and try again.
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
2. Procedures after Completion of Installation
65