Display Analysis Results - SYSMEX pocH-100i Instructions For Use Manual

2.1. ANALYSIS

2.1.7. Display analysis results

• After each analysis the results are displayed on the LCD screen.
• This instrument can store analysis results and histograms for up to 100 samples.
• Values outside the specified upper and lower limits are marked, for further analysis and checking.
The analysis result screen is composed of 4 LCD screen pages.
The first screen
1
Press arrow to switch to second screen.
The second screen
2
Press arrow to switch to third screen.
The third screen
3
Press arrow to switch to fourth screen.
2-11
pocH-100i Revised February 2011
The fourth screen
4
Press arrow to switch to first screen again.
Note
First screen
Displays analysis results of WBC, RBC,
HGB, HCT, and PLT parameters.
Second screen
Displays analysis results of WBC, RBC,
HGB, HCT, MCV, MCH, MCHC and PLT
parameters.
Third screen
Displays analysis results of WBC, LYM%,
MXD%, NEUT%, LYM#, MXD# and
NEUT# parameters, or alternatively
WBC, W-SCR, W-MCR, W-LCR, W-SCC,
W-MCC and W-LCC parameters.
Fourth screen
Displays analysis results of RBC, MCV,
RDW-SD, RDW-CV, PLT, PDW, MPV, and
P-LCR parameters.
Analysis error flag
Sample ID
Analysis mode
Numeric value abnormal flag
! Value is out of the linearity limit.
+ Result exceeds the upper patient limit.
- Result exceeds the lower patient limit.
Result is unreliable.
Volume distribution flag
see "Histogram flags" page 2-12
Date/time
Analysis data
+++.+ Value exceeds display range.
Value could not be calculated be-
.
cause of analysis error.
Value could not be calculated due
---.-
to data error.