A) Analysis In Whole Blood (Wb) Mode - SYSMEX pocH-100i Instructions For Use Manual

2.1. ANALYSIS
2.1.5. a) Analysis in whole blood (WB) mode (for close piercer)
• Check blood with added EDTA anticoagulant, aspirated sample volume ~15μL.
• Required sample volume: >1mL for the ø 13mm tube, > 500μL for the micro tube.
Press "Sample ID".
1
Press "Sample ID".
Enter the ID and press "Ent.".
2
Enter the ID manually or by barcode reader
and press "Ent.".
Press the -button or press "Op-
erator".
3
Press the -button or press "Operator".
2 - 5
pocH-100i Revised February 2011
Select a operator ID.
4a
Select a operator ID.
or
Enter the operator ID and press
"Ent.".
4b
Enter the operator ID and press "Ent.".
Open sample position.
5
Open sample position.
Insert adapter.
6
Insert the correct adapter.
Mix the sample.
7 10
Gently mix the sample. Analyze with or with-
out pierceable cap.
Insert the sample tube and close
the door.
8 11
*
1
Insert sample tube and close the door. ( )
Press "RUN".
9
Press "RUN".
The analysis starts.
The analysis starts. The results are displayed
within approx. 90-125 seconds and are
stored automatically.
Analysis results are automatical-
ly printed according to settings.
Analysis results are automatically printed/
sent to hos t computer according to
settings(from page 5-2).