Hard Drive Installation; Figure 4-7: Hard Drive Bracket; Figure 4-8:Hdd Bracket Retention Screws - IEI Technology ECW-281B-D525 User Manual

ECW-281B/B2-D525 Embedded System

4.2.5 Hard Drive Installation

One 2.5" SATA hard drive supported. The SATA drive is installed into a hard drive bracket
attached on the inside of the bottom panel (

Figure 4-7: Hard Drive Bracket

To install the hard drive into the system, please follow the steps below.
Remove the bottom surface See Section
Step 1:
Remove the hard drive bracket from the bottom surface by removing the four
Step 2:
retention screws that secure the bracket to the bottom surface. (

Figure 4-8:HDD Bracket Retention Screws

Place the HDD into the bracket.
Step 3:
F igure 4-7).
7 6 4
4 .2.3.
7 6 4
F igure 4-8)
7 6 4
Page 39