Configure The Jumper Settings; Figure 4-1: Bottom Surface Retention Screws - IEI Technology ECW-281B-D525 User Manual

ECW-281B/B2-D525 Embedded System

Figure 4-1: Bottom Surface Retention Screws

Gently remove the bottom surface from the ECW-281B/B2-D525.
Step 2:

4.2.4 Configure the Jumper Settings

To configure the jumper settings, please follow the steps below.
Remove the bottom surface. See Section
Step 1:
Locate the jumper settings on the embedded motherboard. See Chapter
Step 2:
4.2.4.1.
. .. 7 6 4
Make the jumper settings in accordance with the settings described and defined
Step 3:
in Chapter 4.2.4.1.
Step 0:
4 .2.3.
7 6 4
Page 33