Figure 4-9: Hdd Retention Screws - IEI Technology ECW-281B-D525 User Manual

Align the retention screw holes in the HDD with those in the bottom of the
Step 4:
bracket.
Secure the HDD with the bracket by inserting four retention screws into the
Step 5:
bottom of the bracket (

Figure 4-9: HDD Retention Screws

Locate the breather hole of the HDD. Cut off the corresponding area of the
Step 6:
breather hole from the thermal pad.
Adhere the thermal pad to the HDD. Make sure there is no obstacle covering the
Step 7:
breather hole (
CAUTION:
Make sure the breather hole of the HDD is not covered. Covering the breather
hole may cause damage to the HDD.
Page 40
ECW-281B/B2-D525 Embedded System
F igure 4-9).
7 6 4
F igure 4-10).
7 6 4