Mounting The System With Mounting Brackets; Mounting The System With Wall Mount Kit; Figure 4-11: Mounting Bracket Retention Screws - IEI Technology ECW-281B-D525 User Manual

4.2.6 Mounting the System with Mounting Brackets

To mount the embedded system onto a wall or some other surface using the two mounting
brackets, please follow the steps below.
Turn the embedded system over.
Step 1:
Align the two retention screw holes in each bracket with the corresponding
Step 2:
retention screw holes on the sides of the bottom surface.
Secure the brackets to the system by inserting two retention screws into each
Step 3:
bracket.

Figure 4-11: Mounting Bracket Retention Screws

Drill holes in the intended installation surface.
Step 4:
Align the mounting holes in the sides of the mounting brackets with the predrilled
Step 5:
holes in the mounting surface.
Insert four retention screws, two in each bracket, to secure the system to the
Step 6:
wall.
Step 0:

4.2.7 Mounting the System with Wall Mount Kit

To mount the embedded system onto a wall using the VESA MIS-D 100 wall mount kit,
please follow the steps below.
Select the location on the wall for the wall-mounting bracket.
Step 1:
Page 42
ECW-281B/B2-D525 Embedded System