Siemens SINUMERIK 840D Series Diagnostics Manual page 82

1 Alarms
Reactions:
Remedy:
Program Continuation:
10203
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10207
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10208
Parameters:
Definitions:
Reactions:
1-82
• 3. Axis interpolation: The number of axes interpolating with one another must not
exceed 4 (this also includes synchronous coupling of axes via synchronous actions "DO
POS[X]=$A..." "DO FA[X]=$A...").
- Alarm display.
- Interface signals are set.
- NC Stop on alarm.
- Interpreter stop
- NC Start disable in this channel.
Modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 NC start without reference point
%1 = Channel number
NC start has been activated in the MDA or AUTOMATIC mode and at least one axis that
needs to be referenced has not reached its reference point.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. Via the channel-specific MD
20700: REFP_NC_START_LOCK (NC Start without reference point) you can decide
whether the axis must be referenced before NC Start or not. The start of referencing can
be enabled channel-specific or axis-specific.
• Channel-specific reference point approach: The rising edge of the interface signal "acti-
vate referencing" (DB 21 - 28, DBX 1.0) starts an automatic sequence which starts the
axes of the channel in the same sequence as specified in the axis-specific MD 34110
REFP_CYCLE_NR (axis sequence channel-specific referencing). 0: The axis does not
participate in channel-specific referencing, but it must be referenced for NC Start, -1:
The axis does not participate in channel-specific referencing, but it need not be refer-
enced for NC Start, 1- 8: Starting sequence for the channel-specific referencing (simul-
taneous start at the same no.), 1 - 31: CPU type
• Axis-specific referencing: Press the direction key that corresponds to the approach
direction in the axis-specific MD 34010 REFP_CAM_MDIR_IS_MINUS (reference point
approach in minus direction).
Clear alarm with NC START or RESET key and continue the program.
Channel %1 error when selecting or deselecting the digitize function
%1 = Channel number
An error has occurred on activating/deactivating the digitizing module; e.g. not in channel
ready state, already activated, etc.
- Alarm display.
Press RESET.
Clear alarm with the Delete key or NC START.
Channel %1 continue program with NC start
%1 = Channel number
After block search with calculation, the control is in the desired state. The program can
now be started with NC Start or the state can be changed for the time being with over-
store/jog.
- Alarm display.
- NC Stop on alarm.
- Program execution is aborted, not effective for single axes
- Interpreter stop
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02