11.02
111112
Definitions:
Reactions:
Remedy:
Program Continuation:
111115
Definitions:
Reactions:
Remedy:
Program Continuation:
111126
Definitions:
Reactions:
Remedy:
Program Continuation:
111127
Definitions:
Reactions:
Remedy:
Program Continuation:
111200
Definitions:
Reactions:
Remedy:
Program Continuation:
111300
Definitions:
Reactions:
Remedy:
Program Continuation:
111301
Definitions:
Reactions:
Remedy:
Program Continuation:
Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Invalid gear stage
An invalid gear stage was requested by the PLC.
- Alarm display.
Check the PLC program and axis-specific NC machine data.
Internal
Programmed position was not reached
The alarms 111110, 111115, 111126, 111127 and 111200 can occur at spindle start/stop.
- Alarm display.
Inform the service department. Please contact the responsible Siemens regional office.
Internal
Absolute value minus not possible
The alarms 111110, 111115, 111126, 111127 and 111200 can occur at spindle start/stop.
- Alarm display.
Inform the service department. Please contact the responsible Siemens regional office.
Internal
Absolute value plus not possible
The alarms 111110, 111115, 111126, 111127 and 111200 can occur at spindle start/stop.
The alarms 111110, 111115, 111126, 111127 and 111200 can occur at spindle start/stop.
- Alarm display.
Inform the service department. Please contact the responsible Siemens regional office.
Inform the service department. Please contact the responsible Siemens regional office.
Internal
Spindle positioning error
The alarms 111110, 111115, 111126, 111127 and 111200 can occur at spindle start/stop.
- Alarm display.
Inform the service department. Please contact the responsible Siemens regional office.
Internal
NC start key defective
Acknowledgement to the PLC user program, that the NC start key is defective, i.e., NC
and NO signal = 1.
- NC Start disable in this channel.
- Alarm display.
Replace the key.
Internal
NC stop key defective
Acknowledgement to the PLC user program, that the NC stop key is defective, i.e., NC
and NO signal = 1.
- NC Start disable in this channel.
- Alarm display.
Replace the key.
Internal
1 Alarms
1-447