Siemens SINUMERIK 840D Series Diagnostics Manual page 169

11.02
Reactions:
Remedy:
Program Continuation:
14097
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14098
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14099
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
1) Value <> 0 corresponds to TRUE, value ==0 corresponds to FALSE.
2) String length 0 => FALSE, otherwise TRUE.
3) If only one character.
It is not possible to convert from type AXIS and FRAME nor into type AXIS and FRAME.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify the program section such that the value range is not exceeded, e.g. by a modified
variable definition.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 string cannot be converted to AXIS type
%1 = Channel number
%2 = Block number, label
The called function AXNAME - conversion of the transferred parameters of the STRING
type to an axis name (return value) of the AXIS type - has not found this axis identifier in
the machine data.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Please inform the authorized personnel/service department. Check the transferred
parameters (axis name) of the function AXNAME to determine whether a geometry,
channel or machine axis of this name has been configured by means of the machine
data:
10 000: AXCONF_MACHAX_NAME_TAB
20 070: AXCONF_GEOAX_NAME_TAB
20 080: AXCONF_CHANAX_NAME_TAB
Select the transfer string in accordance with the axis name and change the axis name in
the machine data if necessary. (If a change of name is to take place via the NC part pro-
gram, this change must first be validated by means of a "Power On").
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 conversion error: no valid number found
%1 = Channel number
%2 = Block number, label
The string is not a valid INT or REAL number.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Modify part program. If it is an entry, then you can check whether the string is a number
via the preset function ISNUMBER (with the same parameter).
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 result in string concatenation too long
%1 = Channel number
%2 = Block number, label
The result of string chaining returns a string which is greater than the maximum string
length laid down by the system.
1 Alarms
1-169