Siemens SINUMERIK 840D Series Diagnostics Manual page 62

1 Alarms
Remedy:
Program Continuation:
6402
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6403
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6404
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-62
• Check whether the magazine data have been defined correctly.
• Check whether there is still room in the magazine to add another tool; there may not be
due to operating procedures.
• Check whether a location type hierarchy is defined and whether it, for example, does
not allow insertion of a type 'A' tool in a free location with type 'B'.
Clear alarm with the RESET key. Restart part program
Channel %1 tool change not possible. Magazine no. %2 not available
%1 = Channel ID
%2 = Magazine number
The desired tool change is not possible. The magazine with the specified number is not
available.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- NC Stop on alarm.
• Check whether the magazine data have been defined correctly.
• Check whether the magazine is connected to the desired toolholder/spindle via a dis-
tance relation.
Clear alarm with the RESET key. Restart part program
Channel %1 tool change not possible. Magazine location number %2 on magazine
%3 not available.
%1 = Channel ID
%2 = Magazine number
%3 = Magazine location number
The desired tool change is not possible. The specified magazine location is not contained
in the specified magazine.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- NC Stop on alarm.
Check whether the magazine data have been defined correctly.
Clear alarm with the RESET key. Restart part program
Channel %1 tool change not possible. Tool %2 not available or not usable
%1 = Channel ID
%2 = String (identifier)
The desired tool change is not possible. The specified tool does not exist or cannot be
inserted.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- NC Stop on alarm.
• Check whether the part program is written correctly.
• Check whether the tool data are correctly defined.
• Check whether there is a replacement tool which can be used for the specified tool.
Clear alarm with the RESET key. Restart part program
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02