Siemens SINUMERIK 840D Series Diagnostics Manual page 387

11.02
61184
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61185
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61186
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61188
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 block %2 no solution possible with current input angle values
%1 = Channel number
%2 = Block number, label
The surface defined via the input angle cannot be processed with the machine. Alarm trig-
gered by following cycles: CYCLE800.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check the angle entered for the swivelling of the machining plane.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 no or incorrect (min > max) rotary axis angle ranges
assigned
%1 = Channel number
%2 = Block number, label
The rotary axis angle range is invalid. Alarm triggered by following cycles: CYCLE800.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check installation and start-up of the swivel cycle CYCLE800.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 rotary axis vectors invalid --> Check installation and start-up
of the swivel cycle CYCLE800
%1 = Channel number
%2 = Block number, label
A rotary axis vector is invalid. Alarm triggered by following cycles: CYCLE800.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check installation and start-up of the swivel cycle CYCLE800.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 no axis name for the 1st axis assigned -> Check installation
and start-up of the swivel cycle CYCLE800
%1 = Channel number
%2 = Block number, label
No axis name was specified for the 1st rotary axis. Alarm triggered by following cycles:
CYCLE800.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check installation and start-up of the swivel cycle CYCLE800.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-387