Siemens SINUMERIK 840D Series Diagnostics Manual page 364

1 Alarms
27202
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
27203
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
27204
Parameters:
Definitions:
1-364
PROFIsafe: MD %1[%2]: address %3 error
%1 = MD name
%2 = MD field index
%3 = Parameterized PROFIsafe address
An incorrect PROFIsafe address was entered in the specified machine data. The value
must be greater than 0.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- NC Stop on alarm.
- Alarm display.
- Interface signals are set.
Correct the MD.
Switch control OFF - ON.
PROFIsafe: MD %1[%2]: SPL assignment error
%1 = MD name
%2 = MD field index
The parameterization of the specified machine data for the link between the SPL interface
and a PROFIsafe module is incorrect because of the following reasons:
• Exchanged bit limits (upper bit value < lower bit value)
• Bit values greater than definition of SPL interface (bit value > 64)
• Number of bits too high for this PROFIsafe module (upper bit value - lower bit value + 1
> 8)
• No SPL assignment parameterized (both bit values equal to zero)
• Incorrect SPL assignment (bit value equals zero)
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- NC Stop on alarm.
- Alarm display.
- Interface signals are set.
Correct the MD.
Switch control OFF - ON.
PROFIsafe: double assignment MD %1[%2] - MD %3[%4]
%1 = MD name 1
%2 = MD field index of MD name 1
%3 = MD name 2
%4 = MD field index of MD name 2
A double assignment has illegally been parameterized in the specified machine data:
$A_INSE parameterized on DMP as well as PROFIsafe modules
• MD $MN_SAFE_IN_HW_ASSIGN
• MD $MN_PROFISAFE_IN_ASSIGN
$A_INSE parameterized on several PROFIsafe modules
• MD $MN_PROFISAFE_IN_ASSIGN
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02