1 Alarms
6640
Definitions:
Reactions:
Remedy:
Program Continuation:
6650
Definitions:
Reactions:
Remedy:
Program Continuation:
6660
Definitions:
Reactions:
Remedy:
Program Continuation:
6670
Definitions:
Reactions:
Remedy:
Program Continuation:
6671
Definitions:
Reactions:
Remedy:
Program Continuation:
6690
Definitions:
Reactions:
Remedy:
Program Continuation:
6691
Definitions:
Reactions:
Remedy:
Program Continuation:
1-74
NC card is not inserted
The NC card cannot be accessed because the card is not plugged in.
- Alarm display.
Plug in the NC card.
Clear alarm with the Delete key or NC START.
Write protection of NC card is active
The NC card cannot be accessed because the write protection is active.
- Alarm display.
Deactivate the write protection.
Clear alarm with the Delete key or NC START.
'Flash File System' option is not set
The NC card cannot be accessed because the option is not enabled.
- Alarm display.
Buy option.
Clear alarm with the Delete key or NC START.
NC card read active
The alarm is active while the contents of the NC card are being read out. The FFS cannot
be accessed during this period.
- Alarm display.
Wait until the read-out procedure is terminated.
Alarm display showing cause of alarm disappears. No further operator action
NC card write active
The alarm is active while the contents of the NC card are being written. The FFS cannot
be accessed during this period. If the power is switched off while the alarm is active, the
contents of the PCMCIA card are destroyed!
- Alarm display.
Wait until the write procedure is terminated.
Alarm display showing cause of alarm disappears. No further operator action
Cycles from NC card cannot be copied to the passive file system.
There is not enough space in the file system that the directories specified in the
$PCMCIA_FUNKTION_MASK can be copied from the NC card to the passive file system.
- Alarm display.
Delete data in the file system.
Clear alarm with the Delete key or NC START.
Cycles from the passive file system cannot be saved on the NC card
There is not enough space on the NC card that the directories specified in the
$PCMCIA_FUNKTION_MASK can be saved. It is possible that cycles are lost during the
next booting.
- Alarm display.
Delete data on the NC card or delete cycles not required.
Clear alarm with the Delete key or NC START.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Siemens AG, 2002. All rights reserved
11.02