Siemens SINUMERIK 840D Series Diagnostics Manual page 219

11.02
Remedy:
Program Continuation:
16000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16005
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16010
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16015
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Correct the part program and add the axis address or the traversing path to the measure-
ments block.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid value for lifting direction
%1 = Channel number
%2 = Block number, label
During the "rapid lift from contour" (keyword: LIFTFAST), a code value for the lifting direc-
tion (keyword: ALF=...) which lies outside the permissible range (permissible value range:
0 to 8) was programmed .
With active cutter radius compensation:
Code numbers 2, 3 and 4 cannot be used in G41
Code numbers 6, 7 and 8 cannot be used in G42 because they code the direction to the
contour.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Program the lifting direction under ALF=... within the permissible limits.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid value for lifting distance
%1 = Channel number
%2 = Block number, label
Mistake in programming: the value for the lifting path must not be negative.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 machining stop after lift fast
%1 = Channel number
%2 = Block number, label
LIFTFAST without interrupt routine (Asup) has been programmed. The channel is
stopped after the lift motion has been carried out.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
After the channel stop, the axes must be retracted manually in JOG and the program
aborted with Reset.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 wrong axis identifier %3
%1 = Channel number
%2 = Block number, label
%3 = Axis name
Axis names from different coordinate systems were used to program axes for LIFTFAST.
The retraction movement is no longer clear.
1 Alarms
1-219