Siemens SINUMERIK 840D Series Diagnostics Manual page 401

11.02
Reactions:
Remedy:
Program Continuation:
61602
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61603
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61604
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61605
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 tool width incorrectly defined
%1 = Channel number
%2 = Block number, label
Plunge cutter is larger than the programmed groove width. Alarm triggered by following
cycle: CYCLE93.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 groove form incorrectly defined
%1 = Channel number
%2 = Block number, label
Radii/chamfers at the groove base do not match the groove width. Face groove on a con-
tour element running parallel to the longitudinal axis is not possible. Alarm triggered by
following cycle: CYCLE93.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 active tool violates programmed contour
%1 = Channel number
%2 = Block number, label
Contour violation in the relief cut elements due to the tool clearance angle of the tool
used. Alarm triggered by following cycle: CYCLE95.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Use a different tool or check the contour subroutine.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 contour incorrectly programmed
%1 = Channel number
%2 = Block number, label
Illegal relief cut element detected. Alarm triggered by following cycles: CYCLE76,
CYCLE77, CYCLE95.
1 Alarms
1-401