Siemens SINUMERIK 840D Series Diagnostics Manual page 535

11.02
Reactions:
Remedy:
Program Continuation:
300909
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300910
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
If STOP C has been triggered, this can have several reasons (depending on the configu-
ration):
1. The safe speed monitoring has been triggered (MD 1361:
$MD_SAFE_VELO_STOP_MODE (SG-specific stop reaction) or MD 1363:
$MD_SAFE_VELO_STOP_REACTION (SG-specific stop reaction) (840D as of SW4.2)).
2. The safe end-position monitoring has been triggered (MD 1362:
$MD_SAFE_POS_STOP_MODE (safe end position stop reaction)).
The alarm indicates the initiation of a "deceleration at current limit" and the internal activa-
tion of "safe standstill".
- NC Start disable in this channel.
- NC Stop on alarm.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. The user must check the
cause and initiate the corresponding measures.
Clear alarm with the RESET key. Restart part program
Axis %1 drive %2 stop D triggered
%1 = Axis number
%2 = Drive number
The drive ws stopped by the NC with STOP D. At the end of the stop reaction, the drive
remains under control, the axis is monitored for SBH.
Request: In monitoring cycle.
If STOP D has been triggered, this can have several reasons (depending on the configu-
ration):
1. The safe speed monitoring has been triggered (MD 1361:
$MD_SAFE_VELO_STOP_MODE (SG-specific stop reaction) or MD 1363:
$MD_SAFE_VELO_STOP_REACTION (SG-specific stop reaction) (840D as of SW4.2)).
2. The safe end-position monitoring has been triggered (MD 1362:
$MD_SAFE_POS_STOP_MODE (safe end position stop reaction)).
The alarm indicates the initiation of a "deceleration on path" in the NC and the internal
activation of "safe standstill" in the NC and drive.
- NC Start disable in this channel.
- NC Stop on alarm.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. The user must check the
cause and initiate the corresponding measures.
Clear alarm with the RESET key. Restart part program
Axis %1 drive %2 stop E triggered
%1 = Axis number
%2 = Drive number
The drive ws stopped by the NC with STOP E. At the end of the stop reaction, the drive
remains under control, the axis is monitored for SBH.
Request: In monitoring cycle.
If STOP E has been triggered, this can have several reasons (depending on the configu-
ration):
1. The safe speed monitoring has been triggered (MD 1361:
$MD_SAFE_VELO_STOP_MODE (SG-specific stop reaction).
2. The safe end-position monitoring has been triggered (MD 1362:
$MD_SAFE_POS_STOP_MODE (safe end position stop reaction)).
1 Alarms
1-535