Siemens SINUMERIK 840D Series Diagnostics Manual page 414

1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
75051
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75060
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75061
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75062
Parameters:
Definitions:
Reactions:
1-414
Incorrect configuration in MD $MA_CC_MASTER_AXIS
%2 = 2 This or the CC_Master axis is a spindle.
%2 = 4 No coupling between rotary and linear axes.
%2 = 8 Axes must not be exchange axes.
- Alarm display.
Check machine data.
Clear alarm with the RESET key. Restart part program
Channel %1 CC_COPON CC_COPOFF error code %2
%1 = Channel number
%2 = Error code
%2 = 1 Wrong argument programmed
%2 = 10 An axis which is not involved in a defined coupling has been programmed in
CC_COPON(x)..
%2 = 20 Too many arguments
%2 = 100 Internal error
%2 = 200 Internal error
- Interpreter stop
Modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 tolerance window exceeded axis %2
%1 = Channel number
%2 = Axis name
The actual value difference between the CC_Slave axis %2 and its CC_Master axis is
outside the configured tolerance window.
- Alarm display.
Check configured tolerance window.
Compare dynamic response settings of coupled axes.
Check mechanical components of axes.
Clear alarm with the RESET key. Restart part program
Channel %1 coupling active axis %2
%1 = Channel number
%2 = Axis name
Machine data MD 63000: CC_MASTER_AXIS has been changed when the coupling was
active.
- Alarm display.
Reset machine data to its old value, switch off the coupling and then enter the new value.
Clear alarm with the RESET key. Restart part program
Channel %1 axes not in standstill axis %2
%1 = Channel number
%2 = Axis name
The CC_Master and/or CC_Slave axes were not at standstill when the coupling was
switched on.
- Alarm display.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02