Siemens SINUMERIK 840D Series Diagnostics Manual page 457

11.02
112504
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
112505
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
112506
Definitions:
Reactions:
Remedy:
Program Continuation:
112541
Definitions:
Reactions:
Remedy:
Program Continuation:
112604
Definitions:
Reactions:
Remedy:
Program Continuation:
112605
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
File faulty or not available: %1
%1 = File name
The program cannot interpret a program block with contour programming.
Contour not in the directory.
- NC Start disable in this channel.
- Alarm display.
Load contour into the directory.
Internal
Error when interpreting the contour %1
%1 = Contour name
Contour is faulty.
- NC Start disable in this channel.
- Alarm display.
Check the contour's machining sequence.
Internal
Maximum number of contour elements exceeded %1
The maximum permissible number of 50 contour elements was exceeded when interpret-
ing the machining sequence of a contour.
- Alarm display.
Check the contour's machining sequence and, if necessary, edit it.
Internal
Program cannot be interpreted
The program cannot be interpreted as a ShopMill program during loading, as the program
header is missing.
- NC Start disable in this channel.
- Alarm display.
-
Internal
Connection to the PLC broken off
Acknowledgement to the PLC user program, that the connection with the PCU has been
broken off.
ShopMill PLC is terminated.
- Alarm display.
Check the PLC user program.
Internal
Asynchronous subroutine was not executed
The input values could not be correctly processed by the NC.
- Alarm display.
Perform an NCK reset
Internal
1 Alarms
1-457