System Reactions On Alarms - Siemens SINUMERIK 840D Series Diagnostics Manual

1 Alarms
1.5
Identifier
Effect
Identifier
Effect
Identifier
Effect
Identifier
Effect
Identifier
Effect
Identifier
Effect
Identifier
Effect
Identifier
Effect
Identifier
Effect
Identifier
Effect
Identifier
Effect
Identifier
Effect
1-598

System reactions on alarms

COMPBLOCKWITHREORG
Block preparation has detected an error which can be rectified by a program modification.
Reorganization is performed after a program modification.
- Correction block with reorganization.
COMPENSATIONBLOCK
Block preparation has detected an error which can be rectified by a program modification.
- Correction block
FOLLOWUP
Follow-up of axes
- NC switches to follow-up mode
INTERPRETERSTOPP
Program execution is aborted after all the prepared blocks (interpolator buffer) have been
processed.
- Interpreter stop
LOCALREACTION
- Local alarm reaction
NOALARMREACTION
- No alarm reaction
NOREADY | NCKREACTIONVIEW
NCK ready off: Active rapid deceleration (i.e. with maximum braking current) of all drives
Clearing of servo enable for all NC axes Release of NC ready relay
- NC not ready
NOREADY | BAGREACTIONVIEW
Mode group ready off: Active rapid deceleration (i.e. with maximum braking current) of the
drives in this mode group Clearing of servo enable for the NC axes concerned.
- Mode group not ready
NOREADY
Channel ready off: Active rapid deceleration (i.e. with maximum braking current) of the
drives in this channel Clearing of servo enable for the NC axes concerned.
- Channel not ready
NONCSTART
It is not possible to start a program in this channel.
- NC Start disable in this channel.
NOREFMARK
The axes in this channel have to be referenced.
- Reference axes in this channel.
SETVDI
VDI interface signal alarm is set.
- Interface signals are set.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02