Siemens SINUMERIK 840D Series Diagnostics Manual page 65

11.02
Remedy:
Program Continuation:
6411
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6412
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6413
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
For information only. The user must decide what to do.
Clear alarm with the Delete key or NC START.
Channel %1 tool %2 / Duplo no. %3 has reached its prewarning limit with D = %4
%1 = Channel number
%2 = Tool identifier (name)
%3 = Duplo number
%4 = D number
Tool monitoring: This message informs that the specified D offset has reached its pre-
warning limit for a time-, quantity- or wear-monitored tool. If possible, the D number is dis-
played; if not, value 0 is assigned to the 4th parameter.
If the function additive offset is being used, additive offset monitoring may be active
instead of tool wear monitoring. The actual type of tool monitoring is a tool property (see
$TC TP9).
If replacement tools are not being used, the duplo number specified has no meaning.
The alarm originates during NC program execution.
- Alarm display.
- Interface signals are set.
For information only. The user must decide what to do.
Clear alarm with the Delete key or NC START.
TO unit %1 tool %2 / Duplo no. %3 has reached its monitoring limit with D = %4
%1 = TO unit
%2 = Tool identifier (name)
%3 = Duplo number
%4 = D number
Tool monitoring: This message informs that the specified D offset has reached its pre-
warning limit for a time-, quantity- or wear-monitored tool. If possible, the D number is dis-
played; if not, value 0 is assigned to the 4th parameter.
If the function additive offset is being used, additive offset monitoring may be active
instead of tool wear monitoring.
The actual type of tool monitoring is a tool property (see $TC TP9).
If replacement tools are not being used, the duplo number specified has no meaning.
The alarm is triggered through the MMC or PLC (=OPI interface). The channel context is
not defined. The TO unit was specified for this reason (see $MC_MM_LINK_TOA_UNIT).
- Alarm display.
- Interface signals are set.
For information only. The user must decide what to do.
Clear alarm with the Delete key or NC START.
Channel %1 tool %2 / Duplo no. %3 has reached its monitoring limit with D = %4
%1 = TO unit
%2 = Tool identifier (name)
%3 = Duplo number
%4 = D number
Tool monitoring: This message informs that the specified D offset has reached its pre-
warning limit for a time-, quantity- or wear-monitored tool. If possible, the D number is dis-
played; if not, value 0 is assigned to the 4th parameter.
If the function additive offset is being used, additive offset monitoring may be active
instead of tool wear monitoring.
1 Alarms
1-65