Siemens SINUMERIK 840D Series Diagnostics Manual page 582

1 Alarms
No. 54
Explanation
Not allowed if
Remedy
No. 55
Explanation
Not allowed if
Remedy
No. 56
Explanation
Not allowed if
Remedy
No. 57
Explanation
Not allowed if
Remedy
No. 58
Explanation
Not allowed if
Remedy
No. 59
Explanation
Not allowed if
Remedy
No. 60
Explanation
Not allowed if
Remedy
No. 61
Explanation
Not allowed if
Remedy
No. 62
Explanation
Not allowed if
Remedy
1-582
Deactivate digitizing. (PI command)
-
-
Switch on function generator. (PI command)
-
-
Switch off function generator. (PI command)
-
-
Wait for a program marker. (Channel communication, NC block: WAITM)
-
-
Wait for end of program. (Channel communication, NC block: WAITE)
-
-
Program selection from another channel, synchronous. (Channel communication, NC
block: INIT + SYNC)
-
-
Wait until receive acknowledge from MMC. (NC block, MMC_CMD)
-
-
Activate the skip block function (VDI signal: skip block)
Nesting depth too great
> Wait until the preceding asynchronous subroutine is terminated or abort the program
Deactivate the skip block function (VDI signal: skip block)
Nesting depth too great
> Wait until the preceding asynchronous subroutine is terminated or abort the program
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02