Siemens SINUMERIK 840D Series Diagnostics Manual page 147

11.02
Reactions:
Remedy:
Program Continuation:
12572
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12580
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12581
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Correction block
- Interface signals are set.
- Alarm display.
Modify program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 %3 only permissible for motion synchronous action
%1 = Channel number
%2 = Block number, label
%3 = Source symbol
The predefined subprogram %3 specified here is only allowed in a block with motion syn-
chronous action. It must not be contained alone in a "normal" block.
- Alarm display.
- Interface signals are set.
- Correction block
Modify program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 %3 not permissible for assignment in motion synchronous
action
%1 = Channel number
%2 = Block number, label
%3 = Source symbol
The variable displayed must not be written in a motion synchronous action. Only selected
variables are permitted here, e.g. DO $AA_IW[X]=10 is not allowed.
- Alarm display.
- Interface signals are set.
- Correction block
Please inform the authorized personnel/service department.
Modify part program.
In a motion synchronous action, only certain variables are allowed.
E.g. $AA_IM, $AC_DTGPB
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid read access to %3 while in motion synchronous
action
%1 = Channel number
%2 = Block number, label
%3 = Source symbol
In a motion synchronous action, the displayed variable must not be entered as a variable
that is to be read on-line, i.e.
1. The displayed variable must not be written to the left of the comparison in a motion syn-
chr. action. Only selected variables are permissible, e.g. WHEN $AA_OVR == 100 DO ....
2. In a motion synchronous action, the displayed variable must not be used as a $$ vari-
able, e.g. WHEN $AA_IM[X] >= $$P_AD[1] DO ... DO $AC_VC = $$P_F
3. The displayed variable must not be programmed as an online evaluated parameter of a
synchronous procedure, e.g. DO SYNFCT(1, $AC_PARAM[0],
$SA_OSCILL_REVERSE_POS2[Z])
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
1 Alarms
1-147