Siemens SINUMERIK 840D Series Diagnostics Manual page 177

11.02
14146
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14148
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14150
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14151
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14152
Parameters:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 block %2 CP or PTP movement without transformation not allowed
%1 = Channel number
%2 = Block number, label
The CP or PTP G code was programmed for a movement but no transformation was
active.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Modify the program.
Clear alarm with the RESET key. Restart part program
Channel %1 illegal reference system for Cartesian manual traverse
%1 = Channel number
In the setting data SC_CART_JOG_MODE, an illegal value has been entered for the ref-
erence system with Cartesian manual travel.
- Alarm display.
Enter a permitted value in the setting data SC_CART_JOG_MODE.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 illegal tool carrier number programmed or declared (MD)
%1 = Channel number
%2 = Block number, label
A toolholder number was programmed which is negative or greater than the machine data
MC_MM_NUM_TOOL_CARRIER.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Please inform the authorized personnel/service department. Program valid toolholder
number or adapt machine data MC_MM_NUM_TOOL_CARRIER.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal tool carrier rotation
%1 = Channel number
%2 = Block number, label
A toolholder was activated with an angle of rotation unequal to zero, although the associ-
ated axis is not defined. A rotary axis is not defined when all three direction components
are zero.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Set angle of rotation to zero, or define the associated rotary axis.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool carrier: invalid orientation. Error code: %3
%1 = Channel number
%2 = Block number, label
%3 = Error code
1 Alarms
1-177