Advertisement
Wiring
4.1 Connections
④
⑤
⑥
⑦
⑧
⑨
Note
Parameterizing output 13 / 14
You will find more information on parameterization in Chapter Parameterizing output 13 / 14
(output signal ON or RUN) (Page 77).
Note
Parameterizing the analog output
You can parameterize the output of the analog output with the 3RW5 HMI High Feature
(Page 109).
54
A1 / A2: Supply voltage for control terminals
Input IN to switch the drive on and off
Output 13, 14: To signal the operating state ON or RUN (parameterizable)
Output 23, 24: To signal the operating state BYPASSED
Output 95, 96 and 98: To signal faults
Analog outputs AQ-, AQ I+ und AQ U+: Connection of an evaluation unit to display the motor
current (optional)
AQ- / AQ U+: For evaluation units with output signal type Voltage, signal range 0 - 10 V
•
AQ- / AQ I+: For evaluation units with output signal type Current, signal range 4 - 20 mA
•
(factory setting)
Manual, 06/2019, A5E37108631002A/RS-AB/002
3RW51 Soft Starter
Advertisement
