Advertisement
Mounting and Dismantling
3.5 Installing / mounting / removing 3RW5 HMI
Procedure with door mounting kit IP65
● Remove the protective film from the adhesive tape on the seal and secure the seal on the
rear side of the 3RW5 HMI Standard
Ensure that the seal does not overlap.
● Place the 3RW5 HMI Standard in the cutout of the control cabinet door
● Continue to screw the screws into the fixing brackets
mm at the front. Fasten the fixing brackets onto the 3RW5 HMI Standard
● Tighten the 3RW5 HMI Standard with a tightening torque of 0.3 ... 0.35 Nm
Ensure that all of the screw heads are in contact with the fixing bracket.
Ensure that the fixing brackets with marking "001" are used.
42
①
.
③
until they protrude approx. 10
Manual, 06/2019, A5E37108631002A/RS-AB/002
②
.
④
.
⑤
.
3RW51 Soft Starter
Advertisement
