Advertisement
9.5
Restore factory setting
Effects of the factory setting
The following devices can be reset to the factory setting:
● 3RW51 soft starter
– The parameters of the 3RW51 soft starter that were not set by means of setting
● 3RW5 communication module
– The parameters of the 3RW5 communication module are reset.
● 3RW5 HMI High Feature
– The parameters of the 3RW5 HMI High Feature and the PIN for access protection are
● All devices
– The 3RW51 soft starter, the 3RW5 communication module, and the 3RW5 HMI High
Procedure
1. Make sure that the motor is switched off and you do not start the motor while restoring the
factory settings.
Make sure that the main voltage is only applied to the 3RW5 soft starter when it is
necessary.
2. Restore the factory settings.
The following procedures are possible:
– With a fieldbus via a 3RW5 communication module (depending on the respective
– Via the 3RW5 HMI High Feature
Result
The factory setting of the selected device or all devices is restored.
3RW51 Soft Starter
Manual, 06/2019, A5E37108631002A/RS-AB/002
elements are reset.
reset to the factory setting.
Feature are reset to the factory settings, as described above.
3RW5 communication module) with the configuration software of the controller (e.g.
STEP 7). Only the communication parameters are reset here.
Restoring the factory settings via 3RW5 HMI High Feature (Page 140)
Restoring the factory settings with the reset button via 3RW5 HMI High Feature
(Page 141)
Maintenance and servicing
9.5 Restore factory setting
139
Advertisement
