Advertisement
3.5.8
Installing the 3RW5 HMI High Feature on a flat surface
Requirements
● Note the mounting positions, minimum clearances and ambient conditions stated on the
data sheet
● 3RW5 HMI High Feature (accessories)
● Level surface, e.g. sufficiently strong mounting plate
● 2 correctly implemented bore holes
● 2 cap screws M4 x 12 DIN ISO 7045 to fit the bore holes
● Screwdriver (depending on the drive of the screws)
● Push-in lugs for wall mounting (accessories)
● Connected HMI connecting cable of suitable length (accessories)
Procedure
● Observe the coding of the plug and socket
● Lock the connector in the socket
● Observe the cable routing in the cable duct
– Cable routing to the bottom
● Connect the connecting cable of the 3RW5 HMI High Feature to the 3RW51 soft starter.
Pay attention to the coding of the plug and socket.
● Insert the push-in lugs into each side of the enclosure until you hear them engage
fix the 3RW5 HMI High Feature on the wall
3RW51 Soft Starter
Manual, 06/2019, A5E37108631002A/RS-AB/002
3.5 Installing / mounting / removing 3RW5 HMI
①
.
②
.
②
③
+
.
Mounting and Dismantling
①
and
49
Advertisement
