Advertisement
Mounting and Dismantling
3.5 Installing / mounting / removing 3RW5 HMI
● Continue to screw the screws into the fixing brackets
at the front. Fasten the fixing brackets onto the 3RW5 HMI High Feature
● Tighten the 3RW5 HMI High Feature with a tightening torque of 0.3 ... 0.35 Nm
Ensure that all of the screw heads are in contact with the fixing bracket.
Ensure that the fixing brackets with marking "002" are used.
Procedure for installing the cable
● Connect the connecting cable of the 3RW5 HMI High Feature to the 3RW51 soft starter.
Pay attention to the coding of the plug and socket.
● Use the opening to the cable duct
● It is possible to route the cable up or down in the cable duct.
Make sure that you install the cable in accordance with EMC requirements. For example,
route data cables separately from the motor cable. Connect both sides of shielded cables
over a large surface area.
46
③
until they protrude approx. 8 mm
①
to install the cable in the 3RW51 soft starter.
Manual, 06/2019, A5E37108631002A/RS-AB/002
④
.
⑤
.
3RW51 Soft Starter
Advertisement
