Thermo Scientific Dionex Easion Operator's Manual page 56

Dionex Easion Operator's Manual
The table below lists the Dionex Easion-related error messages, as well as their
default severity levels. For troubleshooting assistance, go to the page indicated in
the table.
Audit Trail Error Message
Conductivity exceeds limit.
Flow rate calibration error.
Load/inject valve error.
Module data buffer overflow. Data may have been
lost.
Pump motor lost control.
Pump pressure hardware error.
Pump pressure slope calibration error.
Remaining eluent below 100 mL.
Remaining eluent below 200 mL.
The system pressure has exceeded the high
pressure limit.
The system pressure is below the low pressure limit.
Conductivity exceeds limit.
If this error occurs when you turn on the Dionex Easion power, you can
disregard it. If the error occurs at other times, it should be resolved.
To troubleshoot:
Refer to the suppressor manual for troubleshooting procedures.
Flow rate calibration error.
This error occurs if you try to calibrate the flow rate while the pump is off, or
while the pump is on but the flow rate is not 1 mL/min.
To troubleshoot:
Be sure to click Start Calibration on the Wellness panel with the flow rate
calibration instructions. This automatically starts the pump and sets the flow
rate to 1 mL/min. For flow rate calibration instructions, see
48
Default See
Severity Level
Warning page 48
Warning page 48
Error page 49
Warning page 49
Warning page 49
Warning page 49
Warning page 50
Error page 50
Error page 50
Abort page 51
Abort page 51
Section 5.1.3.
Doc. 155028-01 08/20