Considerations specific to the SM-FTN
Warning:
The components within are not user-serviceable.
Warning:
• Use SVT-type power cords in the United States and HAR-type power cords, or
better, in Europe. For requirements elsewhere, contact your local Waters distributor.
• Inspect the power cords for damage and replace them if necessary.
• Power-off and unplug each module before performing any maintenance operation
on it.
• Connect each module to a common ground.
Warning:
without assistance.
See also:
For safety considerations regarding specific system modules, consult the appropriate
information on the user documentation CD.
FCC radiation emissions notice
Changes or modifications not expressly approved by the party responsible for compliance, could
void the user's authority to operate the equipment. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Electrical power safety notice
Do not position the device so that it is difficult to disconnect the power cord.
Equipment misuse notice
If equipment is used in a manner not specified by its manufacturer, the protection provided by the
equipment may be impaired.
Safety advisories
Consult the "Safety advisories" appendix in this publication for a comprehensive list of warning
advisories and notices.
To avoid electric shock, do not remove protective panels from the device.
To avoid electric shock, observe these precautions:
To avoid spinal and muscular injury, do not attempt to lift a system module
June 11, 2019, 715005051 Rev. D
Page iv